| 1 | Reliability test plan | Written test plan specifying sample size, operating conditions, test duration, failure criteria, and acceptance limits for the offered laser product. | Check that conditions and pass/fail criteria are defined before testing; review dated, product-specific reports rather than summary claims alone. | Accept only when the evidence is traceable to the quoted product configuration. |
| 2 | Operating-life evidence | Life-test records stating drive current, optical output, case or ambient temperature, operating time, sample count, and observed failures. | Compare test conditions with the intended application. Do not treat accelerated-test hours as a direct service-life guarantee without a stated model and assumptions. | Prefer documented conditions, results, and limitations over an unsupported lifetime figure. |
| 3 | Thermal design | Thermal path description, allowable case temperature, heat-sink or mounting requirements, and temperature-dependent operating limits. | Review thermal calculations or test data at the intended duty cycle and ambient temperature; confirm the customer’s mounting arrangement is covered. | Require a defined thermal interface and operating envelope before system integration. |
| 4 | Temperature performance | Product-specific optical output and wavelength data across the specified operating-temperature range. | Check measurement conditions, instrument calibration, and whether data refer to the diode, module, or complete laser assembly. | Confirm the stated range meets the application without relying on extrapolated values. |
| 5 | Optical and electrical specifications | Datasheet values and tolerances for wavelength, output power, operating current and voltage, beam characteristics, and duty cycle, as applicable to the product. | Compare the quotation, datasheet, and sample test report; ensure each uses the same model and configuration. | Resolve any mismatch between quoted specifications and measured sample data before purchase. |
| 6 | IEC 60825-1 laser safety | Laser classification information and supporting product documentation for the specific configuration, including applicable labels, user instructions, and protective features. | Verify classification and safety documentation against the product’s wavelength, accessible emission, operating modes, and intended use. Confirm applicability with a competent safety assessor. | Do not infer a safety class from output power alone; assess the complete laser product and its operating conditions. |
| 7 | Production quality control | Incoming, in-process, and final inspection procedures; calibration records; nonconformance handling; and release criteria. | Request sample inspection records and audit the documented process for the product family being quoted. | Look for repeatable, recorded controls rather than statements of inspection without records. |
| 8 | Traceability and change control | Lot or serial-number traceability, revision identification, and a process for notifying customers of material, design, or process changes. | Ask the supplier to demonstrate how a delivered unit can be linked to its production and inspection records. | Require advance notification and approval rules for changes that could affect form, fit, function, or safety. |
| 9 | Driver and protection compatibility | Recommended drive conditions, connection details, protection requirements, and limits for current, voltage transients, and thermal shutdown where applicable. | Review the interface documentation and verify operation using the intended driver and protection circuit. | Confirm that the diode or module is not operated outside its documented limits during startup, shutdown, or fault conditions. |
| 10 | Documentation and support | Current datasheets, drawings, operating instructions, test reports, warranty terms, and a defined technical-support contact or escalation process. | Check document revision and product identity; request written answers to unresolved technical and safety questions. | Prefer complete, consistent, revision-controlled documentation and clearly stated support terms. |